China supplier 50mm 70mm width welded type masonry ladder block work truss mesh
Samples could be sent for evaluation at any time!
The reinforcing ladder structural mesh is configured by welding of galvanized steel rod in H
form or designed angle. Galvanized before welded or galvanized after welded ladder mesh
products are provided by Concreate for horizontal joint reinforcement of the masonry wall system.
In construction, the ladder mesh is put embedded in the horizontal mortar joints of masonry walls.
It consists of two parallel side wire rods with cross rods welded at 16” (400 mm) O. C., thus
forming a ladder configuration. Overall measurement (side-to-side rod) is approximately 2”
(50 mm) less than the nominal wall thickness.
| || Product name: brick mesh, ladder mesh, brick ladder mesh, Ladder truss mesh |
Material: low carbon steel wire, galvanized wire
Wire diameter: 2-6mm
Hole size: 50x50, 50x100, 100x100mm, or as your requirement.
Surface Treatment of Brick Wall Reinforcement Mesh
Welded after hot dipped galvanized;
Welded after electro galvanized;
Welded before electro galvanized;
Welded before hot dipped galvanized;
Welded by stainless steel wire.
Specification of Brick Wall Reinforcement Mesh
andard Mesh Length
Hot Dipped Galvanized After Fabrication
Application Ladder mesh reinforcement also called Brick Wall Reinforcement Mesh is welded wire sheet for reinforced masonry construction. It is used in building surface, wall, ground, bridge, bank and airport. And its feature is that welding spots of warp wire and weft wire are on the same surface.
Contact us if you need more details on Masonry Ladder Block Work Truss Mesh. We are ready to answer your questions on packaging, logistics, certification or any other aspects about Block Work Wire Mesh、Masonry Ladder Truss Mesh. If these products fail to match your need, please contact us and we would like to provide relevant information.
Product Categories : YC-Welded Wire Panel